Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question about spctre "hb" simulation

Status
Not open for further replies.
M

mhtcas

Newbie level 5
Joined
Jul 22, 2008
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,332
When I use the Cadence spectre to run the "hb" simulation for 1dB-compression point of a receiver front-end, an error is encounted.
The simulation--output log gives the error information as follows:
Fatal error found by spectre at time=201.784ns during periodic steady state analysis, during Harmonic Balance Analysis 'sweep-000_hb' , during Sweep analysis 'sweepgb'
FATAL (SPECTRE-7031): SST2 Error: Invalid control value

Could anybody give me some help? Thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top