Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A problem related to Calibre PEX MOS finger

Status
Not open for further replies.
J

jykim

Newbie level 1
Joined
Sep 19, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
Hello, my friends:)

I am extracting parasitics of my layout using calibre.
However, I have a problem related to calibre PEX MOS finger

For example :
Fingers of transistors in my schematic & layout are
W=90, L=1, NF= 15.
However, The result is that in calibreview(calibre) I'm getting transistors in my layout :
W=90, L=1, NF= 1
That is, only MOS Finger NF =1 is extracted in calibre.
I cannot have different MOS finger numbers in calibre.

I must check the exact numbers of fingers for post simulation
because I have a problem with STI stress in using process
So, I need number of MOS finger than NF=1

Can you help me out with this? How can I tell PEX to extract MOS in the right way?
Please help me :oops:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top