Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] flashing lpc1768 on the project

Status
Not open for further replies.
ARM developers typically use the JTAG port both program and debug the device, however this method does require a JTAG ARM programmer/debugger.

Two of most popular commercial JTAG ARM programmers/debuggers are:

Segger J-Link



Of course there are open source alternatives and clones available.

The alternative, in the case of NXP LPC ARM variants, is using a UART PORT and the In-System Programming (ISP) bootloader to load and flash the device with the new image.

BigDog
 

use the following schematic as an easy way for programming(ISP)
 

Attachments

  • 13329732891.jpg
    13329732891.jpg
    108.7 KB · Views: 54

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top