sudiitr
Newbie level 1
Hello everybody.
I am experiencing problem in hardware co-simulation in spartan 3e board. I am designing a system that requires two consecutive multipliers.
for single multiplier the system works fine. however, when both multipliers are there, during generation of JTAG block, towards the end of XFLOW it shows an error, with error code 30.
Can anyone please explain this and suggest a remedy. here are the hardware details:
Board-spartan 3 xc3s-pq208
Hardware used: From register block(shared memory)(2), multipliers(2), gateway out.for 1st multiplier both inputs come from same register.
Register width:-32bit(signed,30 bit floating point)
gateway port-32 bit(IOconnector7 is used)
I am experiencing problem in hardware co-simulation in spartan 3e board. I am designing a system that requires two consecutive multipliers.
for single multiplier the system works fine. however, when both multipliers are there, during generation of JTAG block, towards the end of XFLOW it shows an error, with error code 30.
Can anyone please explain this and suggest a remedy. here are the hardware details:
Board-spartan 3 xc3s-pq208
Hardware used: From register block(shared memory)(2), multipliers(2), gateway out.for 1st multiplier both inputs come from same register.
Register width:-32bit(signed,30 bit floating point)
gateway port-32 bit(IOconnector7 is used)
