Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me get rid of the noise in MCP6024 opamp output

Status
Not open for further replies.
S

sabu31

Advanced Member level 1
Joined
Jan 28, 2011
Messages
445
Helped
12
Reputation
24
Reaction score
13
Trophy points
1,298
Activity points
5,134
Hi
I am sensing ac voltage using opamp(MCP6024) in differential amplifier configuration.When i connect the CRO probes at the output lot of noise is observed in the output. I put 1Kpf ceramic capacitor across the output and ground , however there is no effect.How do we avoid sensor noise pickup.I have attached the waveforms of the actual waveform (blue) and sensed waveform(magenta)
 

Re: Noise in Opamp output

check your opamp detasheet for noise calculation if possible than change your opamp . you can also use high value of capacitor than 1 nf. for checking noise of an opamp ,first give an ideal wave with minimum noise and compare your output with it's input.
 

Re: Noise in Opamp output

It looks like you have connected 0V of oscilloscope to wrong point. Could you show on your circuit and layout the connection point of 0V of oscilloscope.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top