Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cypress EZ-USB firmware ? How to Program or to change the name of Device connected ?

Status
Not open for further replies.
L

laveshkumath

Newbie level 3
Joined
Oct 18, 2008
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
INDIA
Activity points
1,301
Dear Friends,

I am using Cypress CY7C68013 Ez USB FX2LP for developing one hardware software interface via USB.

I got success to develop VHDL Code to Transmit and receive 8 bit data via USB Cable.

Now I am getting message "Cypress USB FX2LP EEPROM missing connected" while I am connecting USB Cable.

I have Cyconsole and Keil software but not getting how to start and write code / firmware, so that my specified name will be displayed in place of "EEPROM missing connected" whenever I will connect the USB cable.

As I am not in touch with C coding, Please help me to achieve the task.

Regards
Lavesh
 

Lavesh,
this answer might be a little late but maybe it helps you or others who are looking into the programability of the FX2. There is a specific forum for Cypress USB devices and many FX2 users share their knowledge. If you ask your question there, the audience will be smaller than here on the edaboard but it has more specific knowledge related to your question.

- - - Updated - - -
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top