RF (transmitter and receiver) module

i have Rf module is following https://www.engineersgarage.com/electronic-components/rf-module-transmitter-receiver. but i don't have any idea to transmit and receive the data from one place to another place. Any one help me. how to interface RF module with micro controller and how transmit and receive the data. tell me from the basic.

using 315MHz rf ASK module to transmit and receive data
http://www.libstock.com/projects/view/278/using-315mhz-rf-ask-module-to-transmit-and-receive-data


You can read additional material about modulations :
http://en.wikipedia.org/wiki/Modulation

hi,
first thing you have to do is to search for the datasheet of your modules. Do you have a transmitter and a receiver or 2 transceiver modules ? (a transceiver is a module that can do both reciving & transmitting)
After you have datasheets of your modules , you can identify how do they "speak" with the outside world ( i do not mean the radio part, let's assume that it does not interest us how the radio link is made for now ....just to keep it simple :grin: ) . The most commonly these kind of modules communicate whit "neighbor" devices thru SPI (serial pheripheral interface).
After you know these things about your modules you have to choose the best fitted microcontroller to your aplication to drive the modules. Driving the modules means that after ' power on ' the microcontroller has to configure the module thru SPI connecton (or other) before actual data transfer. By configure the module i mean to set some specific parameters of module for the radio link to be possible, these parameters are also specified in the datasheets (like: band, data rate, lna gain, bandwith, ..... )

is there any circuit model for transmitting and receiving the data by using micro controller 89s52.i want procedure to do it. I am using separate RF transmitter and receiver.

probably there is, google it ...
i sugest to try to make your own schematic's, take care of supply voltage levels and connections between mcu & radio module , & post it .... in the end you will have a *** circuit and after that you can go to next step : programming ;-)