Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Guitar distortion – a copy of MXR Dist+ and 2x8” box

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


This home made distortion is a copy of MXR Distortion Plus effect.

Construction:
The PCB was made in thermal transfer method. Housing consists of two plates, sanded with sandpaper. Sides were made 4mm thick plywood, angles reinforced. Everything was glued together using a special glue for wood and then varnished. To save space on the pedalboard, sockets are placed on the top of housing. The device uses two-section isostat as a switch. The effect was equipped with not-truebypass, because only the output is switched (another section is for the indicating diode).

Schematic:
Schematic can be found HERE. The battery is cut off by removing the plug from input socket or connecting the power supply.

Pictures:




Link to original thread - Przester gitarowy - Kopia MXR Dist+ i paczka 2x8"
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top