Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to calculate total power consumption

Status
Not open for further replies.
V

vinodv

Newbie level 4
Joined
Jun 21, 2011
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
CHENNAI,INDIA
Activity points
1,312
How to calculate total power consumption of a circuit using Cadence virtuoso? pls help, thanks in advance
 

Measure the current used at the power supply. P=VI
When you are using gates then there might be a bit more calculations needed.
 
  • Like
Reactions: vinodv

    V

    vinodv

    Points: 2
    Helpful Answer Positive Rating
Thanks, I have one more doubt. From that total power , how to find dynamic power,static power and leakage power ? Then is there any relation between the leakage power and static power?
For this calculation is it required to go for RC extraction?
 

I am sure you can find this somewhere, library/internet etc. This is a good digital CMOS book: CMOS Digital Integrated Circuits Analysis & Design by Sung-Mo Kang & Yusuf Leblebici from McGraw-Hill with ISBN:978-0072460537

The average dynamic consumption (From the above book):

\[P_{avg} = C_{load}V_{DD}^{2}f_{CLK}\]

There is also the short circuit current to be considered.

\[P_{avg,sc} = \frac{1}{12}.kf_{CLK}\tau.(V_{DD}-2V_{T})^3\]

For a symmetric inverter

\[\tau = \tau_{rise} = \tau_{fall}\]

\[k = k_{n} = k_{p}\]

There is also your leakage power dissipation.

The total power consumption will be the dynamic, static, leakage and short circuit added together.
This will give you a rough idea of the power consumption, consumption might change in pipeline and
other typologies.
 
  • Like
Reactions: vinodv

    V

    vinodv

    Points: 2
    Helpful Answer Positive Rating
Hai Bass Reitrot,

thanks for ur help. but for calculating Pavg I should know the Cload, for that I should go for RC extraction in Virtuoso? I hope........then other power consumptions like static , leakage, and short circuit.... I should know Istatic, I leakage, Isc......... for that computation any direct method in cadence virtuaso... I am new to cadence.....
 

I am unsure of any direct methods. Usually you calculate the components/currents/capacitors by
hand which is already an estimate and then you measure afterwards in Virtuoso.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top