Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why 216 MHz oscillator fails when connected to diff. mux?

Status
Not open for further replies.
C

chinito

Full Member level 2
Joined
Jul 5, 2004
Messages
128
Helped
11
Reputation
22
Reaction score
6
Trophy points
1,298
Activity points
1,204
216 mhz oscillator

I have oscillator (216 MHz, PECL) connected to differential mux (PECL) on a digital board and fails. I get only noise. Same oscillator works on another analog board. Set up is so simple. What could be wrong with it? Any debugging suggestions?
 

216 MHz Oscillator fails

Check if the power supply is properly decoupled, and make sure that all the connecting tracks have 50 ohm impedance, and terminated with 50 ohm resistors to Vtt (Vcc-2V).

/pisoiu
 

Re: 216 MHz Oscillator fails

Check if Enable/Disable pin is in the right state (is Enabled when this pin is Open or CMOS logic “1”, and Disabled when is “0”)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top