Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

7 Segment RTC Clock with Temperature Display

Status
Not open for further replies.

Jestin_cubetech

Advanced Member level 1
Joined
Jun 24, 2012
Messages
499
Helped
76
Reputation
152
Reaction score
73
Trophy points
1,328
Activity points
3,697
5 Digit 7-Segment
ds1307 - RTC Clock
DS1820 - Temperature Display




clock.png
 
Last edited:

 

Attachments

  • 7segment_clock.rar
    197.4 KB · Views: 417

In schematic, I was expecting a temperature sensor too, why is it missing ? am I misunderstanding something ?

Regards,
Maqbool
 

thank you sir for this interresting project but i thing that theres a problem when it display time bcecause when i run it on isis i see that the hour digit display number one but the time is 21 and i see that you use the pm mode and in that case i think that on lcd must display 9pm can you correct it please or can you send me the mikroC code because im really very interrested on your project and i want to built it for my new room sir
please sir can you help me to realize it with separated 6 seven segment because i was looking to buy 5 seven segment like yours but i can't found it on my country
all my regards sir and thank you agaiinRTC.jpg
 

Set your PC clock in 12 hr Mode

 

Attachments

  • RTC_7seg_with_Temp_Rolling_display.rar
    47.6 KB · Views: 241

thank you so much sir for helping me and i like this new display style
sorry but im very curious and i wish if you help me to do it with separated seven segment bceause i like to do some changes on displaying time on my room
thank you a lot sir all my regards
 

can you help me on that sir??
because i like to make it with big led seven segment sir
 

thank you for helping me
but why i can't wire the 5 segment directly with microcontroller and without the ULN 2003??
 
Last edited by a moderator:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top