Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I make a project which has several schematics. The main IC have a lot of pins conneted to a part in a different schematic.
In the two schematics I put off-page connector as this:
The DRC does not report any warning. The question is, can I connect pins in different schematics like this?
NO YOU MUST USE PORT
Offpage---connection from one page to another page
Port---If the design contains hierachical blocks this is must to transfer the nets from low level block to top level block .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.