Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Cannot Switch layer while routing in Altium Designer10

Status
Not open for further replies.
N

ngkl99

Member level 1
Joined
Dec 1, 2011
Messages
40
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,559
Hi,
when I tried to route and place via, I can switch from bottom to top,
but cannot from top to bottom layer.

But in another board, I can switch either way.
I can't find out the root cause.

May I know what's the problem, any setting that I should check?

Thanks!
 

sorry i solved the problem, just the setting issue.
anyway sorry for disturbing u...
 

ngkl99 said:
sorry i solved the problem, just the setting issue.
anyway sorry for disturbing u...
Click to expand...

Well, what was the setting issue? I'm having a similar problem.
 

Sorry to reanimate this thread but I ran into a similar issue and this thread was one of the first results when searching.

I solved this by looking at my Altium rules. There is a rule under Routing -> Routing Layers and this was set to only allow routing on the component layer. I didn't create this but I did use one of the Altium pre-sets for a four layer board so maybe this gets created automatically?

Just posting in case this helps someone else with the same problem in the future.

Tommy
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top