schwibsi
Newbie level 1
Hello guys,
I am currently converting a couple of 28" bikes into ebikes.
I don't have too much experience with electronics, but I have a bit of soldering experience and it's not going to be too complicated.
The ebike will be powered by 2 5s 5Ah Zippy LiPo packs connected as 10s, with another two 5s packs connected at times as a range extension in parallel to the other 2.
Besides powering the bikes motor, I would like to use the batteries to charge my phone, other USB devices and use it for the bike's light.
What I would like to build is
a little box that
- has a male XT60 socket on the bottom
- undervoltage protection for the LiPo packs with an alarm sound or a LED
- on the side a switch for the power supply and the undervoltage protection
- on the top I would like to have 2 USB sockets for the phone etc.
Would any those be suitable?
Turnigy 5A (8-40v) SBEC for Lipo
Turnigy HV SBEC 5A Switch Regulator (8-42V input)
TURNIGY 5-7.5A (8~42v) HV UBEC for Lipoly
Or would it make more sense to use the 5s packs separately for the USB connectors and use 2 of these:
TURNIGY 3A UBEC w/ Noise Reduction (DE Warehouse)
What would you suggest I use for a housing for everything?
What components should I use?
Any help or suggestions would be greatly appreciated.
Thanks, guys
I am currently converting a couple of 28" bikes into ebikes.
I don't have too much experience with electronics, but I have a bit of soldering experience and it's not going to be too complicated.
The ebike will be powered by 2 5s 5Ah Zippy LiPo packs connected as 10s, with another two 5s packs connected at times as a range extension in parallel to the other 2.
Besides powering the bikes motor, I would like to use the batteries to charge my phone, other USB devices and use it for the bike's light.
What I would like to build is
a little box that
- has a male XT60 socket on the bottom
- undervoltage protection for the LiPo packs with an alarm sound or a LED
- on the side a switch for the power supply and the undervoltage protection
- on the top I would like to have 2 USB sockets for the phone etc.
Would any those be suitable?
Turnigy 5A (8-40v) SBEC for Lipo
Turnigy HV SBEC 5A Switch Regulator (8-42V input)
TURNIGY 5-7.5A (8~42v) HV UBEC for Lipoly
Or would it make more sense to use the 5s packs separately for the USB connectors and use 2 of these:
TURNIGY 3A UBEC w/ Noise Reduction (DE Warehouse)
What would you suggest I use for a housing for everything?
What components should I use?
Any help or suggestions would be greatly appreciated.
Thanks, guys