Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

surface wave in momentum ads?

Status
Not open for further replies.
A

Abu Maria.

Member level 5
Joined
Sep 10, 2011
Messages
80
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,848
hi.
how we can visualize surfaces waves in momentum ads ?
thank u

and when i simulate antenna patch with heigth of substrat =h1 , and after i increase heigth to h2 , I get a enlargement in the bandwidth and an augmentation in directivity and a diminution in gain
this is due to surface wave , because my antenna is well adapted , and i impose loss dielctric equal to 0!

but i can't imagine a propagation of surface wave with inifinite ground plane!
 

please guide me
i simulate (02) groups of (02) patch antennas
1(st) group: epr=2.2 + h(height)=1mm

2(nd) group :epr=2.2 +h(height)=2mm

in first group i found s21=-22.028dB.
in second group i found s21=-23.74dB

normally when i increase height for 1mm to 2mm , coupling will increase , because surfaces wave will be excited , but in my case i found that coupling coupling has decreased !

is momentum ADS takes into consideration the waves sufaces?
and please , SUGGEST me a solution!

thank u
 

please ,
its starting to annoy me , if someone can (simulate theses two group in ads momentum ) , I will be grateful :)
I want to know where is the problem , its very important for me

:::::

:::group1: (02) patch antenna (constant dielctric (epr)=2.2 ; h=1mm ;fr=5.8GHz ) , distance between patch antenna =25.8621mm(distance between port to port not edge to edge) )--------i found s21=-22.028dB

dimonsion of patch antenna (both) : L=16.85mm ; W=9mm

:::group2: (02) patch antenna (constant dielctric (epr)=2.2 ; h=2mm ;fr=5.8GHz ) , distance between patch antenna =25.8621mm(distance between port to port not edge to edge) )--------i found s21=-23.74dB

dimension (both) :L= 15.85mm ; W=12mm


its easy and does not take time :)


I want a confirmation!

thank you very much!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top