Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why are surface mount LEDs recomended pad sizes so small?

Status
Not open for further replies.
G

grizedale

Advanced Member level 3
Joined
Jun 13, 2011
Messages
838
Helped
17
Reputation
34
Reaction score
17
Trophy points
1,298
Activity points
8,804
Page 10 of the following LED datasheet (Xlamp XBD LED) shows a recomended footprint for this LED..........

**broken link removed**


...Why is the anode and cathode pads just 0.284mm wide?

Can i make them wider than that?

For when we make up our prototype boards, we dont have reflow machines, so it will help us if the pads "spill" out to the side a little so that we have something to apply the soldering iron too....but those land patterns are just too small.

We have a hot gas gun, but for obvious reasons, we cannot simply gas-gun this led to the pcb like gets done with mosfets, because we would melt the lens of the LED.
 

Suggested PCB footprints are related to an intended assembly method. For prototype production or other special requirements - change them at will.

For single side assembly, simple hot plate soldering should work well with the suggested footprint, I think.
 
Thanks, i was worrying that maybe if the pads are too big, the pick and place machine may misalign the LED when it places it?
 

Thanks, i was worrying that maybe if the pads are too big, the pick and place machine may misalign the LED when it places it?
Click to expand...
Pick and place is performed according to placement data and hasn't to do with footprint shapes. You'll want to validate the correct alignment in visual inspection, but that's a minor aspect of footprint design. The problem is if the part will keep it's position during reflow. Having the three footprint stripes matched with pads of course promotes self alignment. Enlarging the outer pads would still keep the alignment I think. Or enlarging only the small stubs.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top