Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cut away mor than 1 Brick in CST

Status
Not open for further replies.
R

Rattatuii

Newbie level 3
Joined
Apr 24, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,303
Hello,

how is iht possible to make a hole in a Multilayer designe in CST MWS. For that i inserted a Cylinder in die Multilayer, but than when i Check the Intersection and want to cut it away, it is onyl possible to do that one time. So for all Layers in Multilayer i have to build an Cylinder. Thats very stupid, because it even not possible to copy the Cylinder, because the Parameters in the Definition are done to fix numbers. So if i would change Paramneters of the location of the cylinder (hole in Multilayer) it would not work..


Where is the Solution to make "Cut away that Brick/Cylinder from some other Bricks" ?
 

Not the best solution but better then to create the same cylinder several times:
- Create the cylinder and select "None" in the intersection dialog
- Copy the cylinder several times
- Make a boolean subtract from each layer minus the cylinder
 

Yes but how i wrote thats not possible when i use parameters for the Cylinder like Drills oder the position. If you copy somthing all actual parameters are put to fix numbers. So when i want to change the drill of the hole later, alle boolean substract with the copy cyliner are not done correctly!
 

How do you copy objects?
If you use Objects->Transform->Copy the copied object should have the parameters like the original cylinder.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top