winston_alfred
Newbie level 2
Hi...
I m working on CAN project. I have already brought AT90CAN32 chip. Now the set up is ready. I m using the PONYPROG software on ISP programmer. I m able to write into the chip only if i select the chip as AT90CAN64. It looks like watchdog timer is resetting just after it configures the input output ports. If i disable the watch dog timer chip stops executing. LEDs are halted.
Can anyone tell me the exact configuration of fuse bits for ponyprog for AT90CAN32. some simple code if possible.
Thank You.
I m working on CAN project. I have already brought AT90CAN32 chip. Now the set up is ready. I m using the PONYPROG software on ISP programmer. I m able to write into the chip only if i select the chip as AT90CAN64. It looks like watchdog timer is resetting just after it configures the input output ports. If i disable the watch dog timer chip stops executing. LEDs are halted.
Can anyone tell me the exact configuration of fuse bits for ponyprog for AT90CAN32. some simple code if possible.
Thank You.
