Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] 74ls240 how to enable all outputs permanently?

Status
Not open for further replies.
neazoi

neazoi

Advanced Member level 6
Joined
Jan 5, 2008
Messages
4,123
Helped
13
Reputation
26
Reaction score
15
Trophy points
1,318
Location
Greece
Activity points
36,955
74ls240, how to enable all outputs permanently? where should I connect 1G and 2G ?
 


FoxyRick said:
Looks like a mistake in that datasheet (bad Motorola!). Check the truth table on the following page though - it tells the truth.

The '240 has both active low enables.

Also check TI's - it is correct:

www.ti.com/lit/ds/symlink/sn74ls244.pdf
Click to expand...

Ok so I will tie them both to GND, to make the chip always enabled!

Thank you very much!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top