kesavparu
Newbie level 4
hi
i unable convert .dra (allegro board file) to orcad layout(.max).
i am able to convert .max to .dra, but i am not able to convert .dra to .max.
i am following some stepls, i am mapping all layers,classes,sub classes in allegro dxf editor, i converted into dxf format.
but on importing .dxf file into orcad layout plus(.amx) only silkscreen ,out line is comming,but pads are not comming.
please fix this problem.
thanking u
p.kesav.
i unable convert .dra (allegro board file) to orcad layout(.max).
i am able to convert .max to .dra, but i am not able to convert .dra to .max.
i am following some stepls, i am mapping all layers,classes,sub classes in allegro dxf editor, i converted into dxf format.
but on importing .dxf file into orcad layout plus(.amx) only silkscreen ,out line is comming,but pads are not comming.
please fix this problem.
thanking u
p.kesav.