Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to generate ideal balun in layout?

Status
Not open for further replies.
R

rajeshree

Junior Member level 2
Joined
Feb 6, 2012
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,426
Hello everyone
i have generated layout of OTA design shown below. DRC is sucessfully run without ideal_balun
But i dont know how to connect ideal_balun in layout. please help me i got xfmr component error in LVS.
How can i solve it? thanks in advance
pro_ota.png
 

Hello rajeshree,

You need to remove the balun and the Voltage sources and add pins.
 
Thanks a lot sir
but i want to apply differential ac inputs to two inputs and input common mode voltage simultaneously than how is it possible? please suggest me how to do?
thanks in advance
 

After you add the pins you will need to make a symbol. [Create -> Cellview -> From Cellview]
Then you will run the simulation in another file, where you will add your circuits symbol, the necessary sources and the balun.

---------- Post added at 17:42 ---------- Previous post was at 17:38 ----------

Also check this file at pages 11 to 13

**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top