Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to make pcb layout??

Status
Not open for further replies.
J

jazeel06

Junior Member level 3
Joined
Mar 21, 2012
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,426
how to make pcb layout of this ckt?


i cannot find library of 2n5777 phototransistor and dpdt relay in orcad 9.1 and dip trace software.
pls help me fast.....
 

Unless you can find someone who has already created this part, you're going to have to create it yourself. It's just a fact of life that not EVERY component in the world is going to be supplied by the vendor, and you have to create your own schematic and pcb layout symbols. Your phototransistor might be in a standard package, so that you don't have to create the pcb decal from scratch.
 

i dint get u...can u be more clear??
 

What do you need exactly, a schematic symbol? a pcb decal? for what software? In any case, if you can't find the part you need in the library, you will need to create your own.
 

jazeel06 said:
how to make pcb layout of this ckt?


i cannot find library of 2n5777 phototransistor and dpdt relay in orcad 9.1 and dip trace software.
pls help me fast.....
Click to expand...

I can make LIBs for you or whole layout. I work in Altium Designer Summer 09

Looking forward.

Regards,
Maqbool
 

You are not allowed to do so anywhere but the business or advertise section in this forum.
Consider this a warning.
 

alexan_e said:
You are not allowed to do so anywhere but the business or advertise section in this forum.
Consider this a warning.
Click to expand...

Hi Dear,

I joined EDABOARD earlier, but using it now. I am not much aware, so did this mistake.

Most of the time, I use elance, guru, freelancer etc, and very much use to of offering services. Next time, I will be careful about it. I apologies for violating the rules.

Thank you for guiding me.

Maqbool
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top