Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to extract dc component from a signal in simulink using low pass filter?

Status
Not open for further replies.
S

sunnycfc9

Newbie level 3
Joined
Mar 27, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,297
How to extract dc component from a signal in simulink using low pass filter?

The source frequency is 50HZ and I would like to extract the dc component of the signal.
I am using low pass filter in simulink but I do not know how to determine the cut off frequncy?

The signal dc component that I would like to exract is shown below.


 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top