Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS warning: Polyline edges found on strip layer

Status
Not open for further replies.
S

Samkeet

Newbie level 4
Joined
Dec 14, 2011
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,331
Hello ppl,

While I am performing MOM-RF simulation for a balun layout on a multilayer PCB, I am getting this warning:

"Polyline edges and/or wires have been found on
STRIP layer <mask 66> and will be ignored. Their
location has been written to the DRC report."

I am not sure about the gravity of this warning. Also if someone can hint me what might be causing this warning and its effect on my S-parameter results.

Hoping for a quick reply.

Thank you

Samkeet
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top