Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use the L298 for DC motor driving

Status
Not open for further replies.
S

srikanth977

Newbie level 5
Joined
Jan 11, 2012
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,349
Hi all, I have just started programming 8051 .

I want to control a geared dc motor ( 12 V)
I am using the l298 driver.

I could connect the In1, In2, EA to controller and OUT1 and OUT2 to the motor. and connected SenseA to GND
I want to vary the current of the load(motor).
Please help me to increase the current as the motor is rotating very slowly.

Thanks for reading.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top