Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, i am designed a OpAmp usig Tanner EDA 15 now i have to draw the layout for that.Please tell me how to convert my schematic to layout automatically in Tanner EDA15.
You use S-EDIT for your schematic, LEDIT is for the layout. To transfer your schematic to a layout, you need to use SDL. just go to File>Export>SPICE
In the SPICE dialog, you'll see a list at the bottom, type "SDL". then export your SDL SPICE netlist that resulted by clicking OK.
In LEDIT go to Tools > SDL, then import that netlist.
LEDIT will then instance the devices in the schematic for you, you can now connect them either manually or use Auto-Routing.
Auto-Routing will route everything for you automatically, all you have to do it set up the routing from Tools.
You use S-EDIT for your schematic, LEDIT is for the layout. To transfer your schematic to a layout, you need to use SDL. just go to File>Export>SPICE
In the SPICE dialog, you'll see a list at the bottom, type "SDL". then export your SDL SPICE netlist that resulted by clicking OK.
In LEDIT go to Tools > SDL, then import that netlist.
LEDIT will then instance the devices in the schematic for you, you can now connect them either manually or use Auto-Routing.
Auto-Routing will route everything for you automatically, all you have to do it set up the routing from Tools.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
