Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Without details like the core type, material, AL, etc. the only thing you can do is to use thick wire that can handle 12A or use multiple thin wires which can handle 12A total and wind on the coil and every few turns, take a reading with an LCR or inductance meter. Keep on doing this until you have 150uH.
If you know the AL value of the core, you can calculate how many turns you will need and then do a final tuning to adjust for 150uH.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
