Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
There are only three choices - VECTOR, PROPORTIONAL or FIXED.
In order to see the changed font you need to turn OFF the "always vector font" option in the "Options" "User Interface" and also the "Persistent in this drawing option". However, this could cause problems when you try to create the manufacturing files. It is best to stick with the vector font.
If you want to change the "readability" of the font you can change the "RATIO". This is 8% (line width as a percentage of height) by default. A higher number will create a bolder font.
Keith
PS By the way - to change the font type "change font" in the command line and hit enter - it will then ask for which type you want to change to.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
