Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Flicker Noise Corner Frequency

Status
Not open for further replies.
E

eng-a-hesham

Junior Member level 2
Joined
Oct 14, 2011
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,427
according to what should i select "flicker noise corner frequency" that should be achieved in my system blocks design ?!
 

Depending your active device...It may be few hundred Hz to few tenth MHz...
 

As was stated, 1/f corner could be between hundreds of Hz and few MHz.
10kHz would be a lucky guess if is not mentioned the type of the active device used.
 

what do you mean by (type of active device) ?!? do you mean the technology used in design ??! or what !!

and does it have any rule ,or it's just by experience !!
 

I mean, JFET, BJT, GaAs FET, CMOS, have totally different flicker noise corner.
 
ok , now i decided to use CMOS technology .. still don't know based on what should i specify flicker noise corner.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top