Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
if i have some loads that are connecting in parallel , each load is activated by a relay that takes the permission from a micro controller... I am asking for how can i know or measure for a presence of a load or not ??or its being in service or out of service
Hello mostafa
As i understood , you want measure your load , and then you want change your load . is your load reactive ? or active ? or complex ?
As i think , you want make a capacitor bank ? isn't it?
Good luck
Goldsmith
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
