Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is the meaning of "solution frequency" in HFSS analysis setup?

Status
Not open for further replies.
D

dragonolj

Newbie level 6
Joined
Apr 23, 2009
Messages
14
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,370
Hi,

I am learning HFSS simulation. I don't understand the meaning of "solution frequency" in analysis setup. How to setup it?

I am trying to simulate a parallel plate waveguide, which has TM1 cut off frequency at 2GHz. If I want to see TM1 mode, I need to setup this solution frequency higher than 2GHz. Am I right?

Thanks in advance.
 

Hello

The Minimum value for adaptive mesh frequency is 2/3rd of the final frequency required.although you can have it set up for final frequency

When analyzing modes the cut off frequency should be kept in mind,i would say you set up a solution frequency of 3GHz to get proper results.

Regards
ChachitoEL
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top