kbmanick
Full Member level 1
Hi,
I am using Hyperlynx 8.1.
I created a Multiple layer PCB. I am not able to edit the Zo value of plane. Even If I change the Z0 value to zero, it automatically changes to 75 ohm.
In general, Z0 is zero for ground and power plane.
It will be helpful If I get a support.
I am using Hyperlynx 8.1.
I created a Multiple layer PCB. I am not able to edit the Zo value of plane. Even If I change the Z0 value to zero, it automatically changes to 75 ohm.
In general, Z0 is zero for ground and power plane.
It will be helpful If I get a support.