Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Power supply with LNK306

Status
Not open for further replies.

ajanogi

Newbie level 4
Joined
Dec 20, 2009
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,339
Hello Everybody.

I need a transformerless power supply. 220V AC 50Hz to 12, 15 or 20V DC. I found a circuit and just saw this converter LNK306GN. I get the chip and try the circuit but i cant get the DC voltage. You can see my schematics that i've attached.

Firstly, i tried not to use zener. In application note (AN37) it says for buck converter, 11.86k and 680uH gives 12V 430mA out. But i couldn't found that product. So i used 13k adn 680uH and see 25V output.

And when i tried to use zener or voltage dropper i cant get any voltage. Just zero.

So i really need to use this product for transformerless power supply Please help me. By the way i used 1n4005gp but after it s blow i changed it 1n4007.

 

your circuit is ok but please note that all source "S" pin should be connected. If it is already done please chacke all components.

Regards.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top