Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] How to use GoldenGate simulator to see the phase noise of an oscillator

Status
Not open for further replies.
W

wht4665453123

Newbie level 6
Joined
Jan 19, 2010
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
U.S.A.
Activity points
1,374
Dear all,

I'm using the CR analysis of the GoldenGate simulator to simulate an oscillator. May I know how can I plot the Phase Noise?

I remember that in Spectre, we run the PSS then PNOISE so as to see the phase noise.

Thank you very much.
 

In Agilent GoldenGate Simulator there is no separation between master large signal steady state analysis(e.g. PSS) and slave small signal analysis(e.g. PAC, PXF, Pnoise).

Simply run Autonomous CR with noise analysis.
 
Last edited:
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top