lambchops511
Member level 1
Previous there was this option to edit the PSPICE config file so that the output is displayed even if there is a error in the simulation. i.e. doing transient analysis for 5s, and there.s an error at 2.5s ... the PSPICE would run up to 2.5s display that before failing out.
I can't find this option again and I don't remember what I googled last time... any ideas?
Thanks.
---------- Post added at 12:20 ---------- Previous post was at 12:10 ----------
i remember editing pspice.ini if that helps...
I can't find this option again and I don't remember what I googled last time... any ideas?
Thanks.
---------- Post added at 12:20 ---------- Previous post was at 12:10 ----------
i remember editing pspice.ini if that helps...