Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello i am not well in HFSS can any one please tel me how todo the connexin (i use a rectangle for patch and for GND (PerfectE) how connect them) in figure attached and if i must use a coaxial or simple port
thanks in advance
the set up is quite easy you can do it two ways either have your coaxial connector connected the way shown or through a via going passing substrate. to do this draw the inner conductor touching the inverted-F and the outer coax touching the ground plane.if you would like i can show you how to do it at the condition that you have planar inverted F designed already on hfss.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
