Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Tx and RX pins of PIC 16F877a

Status
Not open for further replies.
E

E11022

Junior Member level 2
Joined
Feb 28, 2010
Messages
21
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,474
there is only 1 Tx pin and 1 Rx pin in the Pic 16f877a.
If i use the tx and rx pin for remote control circuit, can i use the same pin to connect to PC for serial comm?

I have an idea for my remote control circuit, not sure can it work.
i am NOT using any Microcontroller for my TX part of the remote control,my Tx circuit is just TWS module to HT12E to 2 input switches.
However, my RX circuit is connected to PIC16f877a. i am thinking of directly fed the output data from HT12D to any port of the PIC16f877a which the data will act as an input. If the data is high, the PIC process the data and the buzzer will goes off.

Is this possible??
 

You can multiplex TX signal and choose the device you need to control at time.
Once another RX is not required at uC, there is no restrictions to do what you said.

+++
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top