Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

RF to DC converter using Agilent ADS???

Status
Not open for further replies.
J

JMECE108

Newbie level 2
Joined
Dec 3, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,310
Hi good day everyone! Can anyone help me simulate the RF to DC converter circuit that I have created in Agilent ADS? I want to know the output voltage given an input frequency (915 Mhz) and also the correct specs like the width and length for my microstrip design? THank you
 

1) design an antenna
2) design a bandpass/ low pass filter
3) design a rectifier cct ( diode)
4) combine all the design together with matching circuit
 

JMECE108 said:
Hi good day everyone! Can anyone help me simulate the RF to DC converter circuit that I have created in Agilent ADS? I want to know the output voltage given an input frequency (915 Mhz) and also the correct specs like the width and length for my microstrip design? THank you
Click to expand...

If you have the circuit, run a Transient analysis. Inject an AC signal and look at the output node voltage vs. time to see the result.

As for microstrip, since you have ADS, go to Tools and start LineCalc. Use an MLIN (Microstrip LINe), enter your substrate parameters, enter your frequency and impedance/electrical length values, then hit the Synthesize button.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top