Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to reduce the BER in simulink model for a tx rx chain?

Status
Not open for further replies.
S

shumail

Junior Member level 1
Joined
Jun 7, 2011
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,385
hi,
can anyone tell me how to reduce the BER in a simulink model. it starts with rand signal gen, then BFSK, then upconversion and finally to speaker from where mic recieves signal via air or a simple wire, down converts filters and demodulate the signal. But when i calculate the BER of this model, it comes out to be 0.5. how to make it zero??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top