Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PCB Designing for filter and IC based circuits

Status
Not open for further replies.

manieceindia

Banned
Joined
Nov 18, 2011
Messages
7
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
Bangalore
Activity points
0
Dear friends,


I'm beginner for PCB designing, kindly help me how to select values of resistor and capacitor in IC based and Filter based circuits


Regards,
Manivannan Selvaraj
 

In the beginning one can make PCB arbitrarily with or without application for practice.
In the course of all this one may come across what are
IC based circuits
and what are
Filter based circuits

and also their specifications. These specifications will dictate design.

Right now you are at PCB design. Work on that right from schematic trough netlist, component layout, manual and auto, routing etc till the final artwork, its printing, etching, masking, drilling etc.


Hope this helps !!!!
 
PCB deisgn have following steps broadly -
1) Analyze the functionality that you want to implement in the baord and select appropriate Chips and components
2) Development of schematic diagram ( Circuit that you want)
3) Then generate the netlist and import that netlist in to PCB routing editior
4) Route the complete circuit on the PC using PCB routing editor
5) then generate garber file and send that files to PCB manufactors

you will get the you PCB made....

I uses KiCAD for this ....as it is free....

Good Luck
 
Last edited:
Work on the sample PCB projects that come along with PCB design software package. For a PCB designer value of components does not make any difference. Only the footprint does... :)
 
Component values don't seem particularly related to PCB design. It's a question of filter circuit dimensioning and applies on a breadboard as well.
 

Dear friends,


I'm beginner for PCB designing, kindly help me how to select values of resistor and capacitor in IC based and Filter based circuits


Regards,
Manivannan Selvaraj

Hi,

Go through this PDF it might give you an clear picture about PCB Designing.
 

Attachments

  • pcb-rule.pdf
    232 KB · Views: 66
  • PCB Basics.pdf
    1.9 MB · Views: 81
Hi,

Go through this PDF it might give you an clear picture about PCB Designing.

Hi,
I'm not getting any pdf.

---------- Post added at 05:42 ---------- Previous post was at 05:41 ----------

Hi,
YES, I GOT....
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top