Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Cheap energizer – own construction

Status
Not open for further replies.

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


The system is simple and reliable. The main element is impulses generator. It bases on LM555(NE555) and generates a signal for transistor's T1 base, which then closes the circuit of the coil mass. The result is a simple interrupter.

8720663200_1305880720.gif


The coil in this case is a coil from Fiat 126p.



It generates a high voltage of several kilovolts. The frequency of the output voltage is identical to the factory designs, what is 60 pulses per minute.
Operating frequency depends on the capacity of the condenser 10uF.
The plate based on the scheme was designed in KiCAD.



Below there are some photos:




Inside of the housing was flooded in silicone mass to avoid weather conditions.

Link to original thread – Tani elektryzator własnej konstrukcji
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top