Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Noise Figure Matching

Status
Not open for further replies.

youngguns21

Member level 2
Joined
Jun 7, 2010
Messages
42
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,630
Hi all,
I am doing an input network to match noise figure of a FET, but I get stuck trying to match the low freq of the network to the low freq of Γopt and high freq to High freq.

I can match them one at a time, but is there a way to reverse direction on the smith chart? The optimum NF follows a curve counterclockwise in frequency, but nothing I do can make a matching network do the same.

Any tips or hints?

Thanks-Kyle
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top