prathap reddy
Newbie level 4
I have two problems
1)For my project i need to simulate 14 analog input to pic16f887 controller(it will support upto 14 analog inputs).
i was done coding for this.
i was faced a problem with ANSEL=0xFF;,ANSELH=0x3F;
how to intialize 14 analog inputs in MiKro c, for pic16f887?????
2)I am using proteus s/w for simulation.
If i give equal resistanance to each analog input pin the simulation is not working.
It is giving the following error...........
GMIN step failed,
source failed,
too many iterations without convergence,
real time simulation failed to stop.
Can any one help????????????
1)For my project i need to simulate 14 analog input to pic16f887 controller(it will support upto 14 analog inputs).
i was done coding for this.
i was faced a problem with ANSEL=0xFF;,ANSELH=0x3F;
how to intialize 14 analog inputs in MiKro c, for pic16f887?????
2)I am using proteus s/w for simulation.
If i give equal resistanance to each analog input pin the simulation is not working.
It is giving the following error...........
GMIN step failed,
source failed,
too many iterations without convergence,
real time simulation failed to stop.
Can any one help????????????
