Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

AWR VSS and Matlab Co-Simulation

Status
Not open for further replies.
A

avins_1234

Member level 3
Joined
Nov 12, 2009
Messages
58
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,286
Activity points
1,676
Hello,

I am simulating a design - this is for matlab VSS co-simulation.

I have used two saw tooth blocks and connected them to matlab block in VSS. When I run this, I get the message.

Executing STARTCMD: Attempt to reference field of non-structure array.

The schematic is as shown.

matlab_vss.JPG

The matlab graph window opens, but does not show any thing.

Regards,
Avs
 

avins_1234,, if you heppend to solve problem, could explain how?...
 

Hello,

I have not yet got the solution.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top