Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Zigbee Programming Help Needed

Status
Not open for further replies.
A

atozbydc

Newbie level 1
Joined
Oct 4, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi Everyone,

I need to know which is the best language to write a Zigbee Programming and how do i link the program with my zigbee? i have done "talking" with my XBee Pro 900 Wire Antenna (sku: WRL-09097) using X-CTU.
 

atozbydc said:
I need to know which is the best language to write a Zigbee Programming and how do i link the program with my zigbee?
i have done "talking" with my XBee Pro 900 Wire Antenna (sku: WRL-09097) using X-CTU.
Click to expand...

Use the language which you are most comfortable. You will be primarily issuing AT Commands, transmitting and receiving ASCII character strings.

I assume you have a pair of these XBee modules? Have you successfully formed a link between the two?

XBee-PRO® 900/DigiMesh™ 900 OEM RF Modules Manual

According to the product page, the XBee Pro 900 are shipped with the DP multipoint proprietary firmware which should provide out-of-the-box communications, no setup required.

What type of breakout board are you using in conjunction with X-CTU to provide a serial interface?

BigDog
 

Can use AT command. Actually, for first time use, no need to set. You can use default setting to interfacing with UART 9600 baudrate.
See this XBee Lesson.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top