Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Modelling OTA non linearities

Status
Not open for further replies.
samiurrehman

samiurrehman

Member level 2
Joined
Aug 30, 2010
Messages
49
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
Pakistan
Activity points
1,729
How can I model Operational Transconductance Amplifier (OTA) non linearities to extract the accurate transistor level specifications? Is there any MATLAB toolbox which can yield such specifications??????
 

Hi,
The transistor level specifications would depend on the OTA architecture you are using.

But, in general OTA is similar to any TA; TA amplifies single-ended signals whereas the difference of two signals will be amplified in an OTA.

* The gain of OTA is still Gm*Ro
* slew rate is Imax/Cload
etc.

I would follow the following procedure: identify the architecture, build a small signal model, identify how the specifications (like gain, slew rate, etc) depend on the transistors and get the transistor-level spec.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top