wave1990
Newbie level 1
Hi!
First of all thanks a lot for this beneficial site.
I’m making a Wilkinson Power Divider in Ansoft HFSS 10.
It has to be an equal split power divider(Z0=50 ohm) which has to be driven at 5Ghz.So that I set the solution frequency 5Ghz.
According to the graph there is something wrong with the system(3dB point cannot seen at 5Ghz).Do you have any sugesstions?
•One problem I can able to see;when I change solution freq. There is no difference between the graphs.
•Thin resistor material;tantalum nitride;but it’s dimensions are choosen arbitrary.
Thanks for replys.
First of all thanks a lot for this beneficial site.
I’m making a Wilkinson Power Divider in Ansoft HFSS 10.
It has to be an equal split power divider(Z0=50 ohm) which has to be driven at 5Ghz.So that I set the solution frequency 5Ghz.
According to the graph there is something wrong with the system(3dB point cannot seen at 5Ghz).Do you have any sugesstions?
•One problem I can able to see;when I change solution freq. There is no difference between the graphs.
•Thin resistor material;tantalum nitride;but it’s dimensions are choosen arbitrary.
Thanks for replys.