Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Even and Odd mode resonance frequencies

Status
Not open for further replies.
A

amir88

Advanced Member level 4
Joined
Nov 4, 2009
Messages
118
Helped
13
Reputation
26
Reaction score
8
Trophy points
1,298
Location
bandarabbas
Activity points
1,926
Is there any way to discriminate even and odd mode resonance frequencies (in ads or cst) without solving complicated equations? If so, plz explain it. Current density can help us??
Regards,
 

In general, symmetry boundaries can be a very nice way to create an artificial mode filter in a structure. For example, if I take a rectangular 2D waveguide, cut if in half, and assign the plane of cut with a PEC boundary (and assign the correct impedance multiplier), then I will only be solving for odd modes that exist in the overall structure.

Hope this helps
 
Consider the following image:

There are 3 Res. Freq. I want to know which one is related to odd or even mode.
 

In an empirical way, you can slightly change the gap in the two coupled lines, and that will shift the resonances that depend mostly on odd mode excitation. You can then keep the gap constant, and change the line width of the two coupled lines, which will change the resonance of the even mode more.
 

thank you for your hint biff44.but
why will gap change shift odd mode, while the width change shift even mode resonance freq.?
would you explain it more precisely,please?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top