Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Updating pcb file and error in validating

Status
Not open for further replies.
B

baby_1

Advanced Member level 1
Joined
Dec 3, 2010
Messages
415
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
4,277
hello dears
i created a circuit in schematic and update it to pcb file.it works fine.but when i delete all of them in pcb and the want to update it shows my this failed validate in update.how can i solved it?

 

you have to give footprints each of component again ....because once you have already deleted all the footprints.....
if you are doing this in altium then go to schematic page >tools>footprint manager >select any component >edit or add>then select foot print accordingly >validate it >accept changes ..........
this you have to do for each of component ,,,,,but if you are having so many cap or resistor u can select all capacitor and can change footprint ..in one time only for all the capacitor or resistors....

hope it will help you
 

Thanks raksha singh
but i still have this problem

 

as matter of fact yes.i told you i update my pcb and then delete all of them from pcb in the next update i have this problem.could you test it with a simple circuit in schematic and then transfer it to pcb teh delete them from pcb and again update pcb you can see this problem..
 

sorry for late reply check your schematic...and also check footprint ...............i will too try this with a simple schmatic design then let you know.....till then you check all above things////

---------- Post added at 06:17 ---------- Previous post was at 06:03 ----------

if all above things are done properly so also check that your sheets should be under a source document not in free document .......if your document is in free make it a source document ..i have done it .....and the way i told you it is working here .......
 
  • Like
Reactions: baby_1

    B

    baby_1

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top