emyboard
Newbie level 2
Hello members, am using Agilent ADS software to carry out performance studies on Mobile WiMAX (802.16e). My studies are based centrally upon the performance of Mobile WiMAX and on its use of Multiple Antenna Adaptive Systems [MIMO(Multiple-Input-Multiple-Output)] channels to improve network coverage, increase throughput and decrease the bit or packet error rates .
I am to carry out performance simulations on this, checking the fading levels, sensitivity, constellation points etc.
I have started simulating on the templates on the "mobile_wimax_mimo_Rx_prj". I made some changes such as "antenna correlation type", "Rate ID", "Decoder type" etc.... , but after the simulation was completed, it displayed the trace and plot options only. I keyed-in the necessary values and details, but at the end of it all, it didn't display any graphical results, but only displayed an empty graph showing x-axis and y-axis.
Anyone with a clue on this should please help me out, because i don't have much time anymore.
Thanks,
Emyboard.
I am to carry out performance simulations on this, checking the fading levels, sensitivity, constellation points etc.
I have started simulating on the templates on the "mobile_wimax_mimo_Rx_prj". I made some changes such as "antenna correlation type", "Rate ID", "Decoder type" etc.... , but after the simulation was completed, it displayed the trace and plot options only. I keyed-in the necessary values and details, but at the end of it all, it didn't display any graphical results, but only displayed an empty graph showing x-axis and y-axis.
Anyone with a clue on this should please help me out, because i don't have much time anymore.
Thanks,
Emyboard.